WARP Project Forums - Wireless Open-Access Research Platform

Sunny · 2015-Jul-30 01:18:38

Hello sir,
I would like to use Simple Streaming Reference design for my WARP-V1 (Vertex-2 Pro FPGA) boards, what is the exact IF(Baseband Up-conversion) frequency of the design?

thanks

regards
Sunny

murphpo · 2015-Jul-30 08:41:23

The simple streaming design uses a 10 MHz IF. The IF mixer is implemented digitally as part of the Tx/Rx PHY. The WARP hardware radios are all direct-conversion (zero IF).

A good resource for understanding the Simple Streaming design is the Rice ELEC 433 course. The Simple Streaming design started out as the lab project for this course. The ELEC 433 slides and lab handouts are all relevant to the design of the Simple Streaming PHY.

WARP Project Forums - Wireless Open-Access Research Platform

#1 2015-Jul-30 01:18:38

What is the Intermediate Frequency(IF) of Simple Streaming Ref design?

#2 2015-Jul-30 08:41:23

Re: What is the Intermediate Frequency(IF) of Simple Streaming Ref design?

Board footer