|
Last change
on this file was
4469,
checked in by welsh, 9 years ago
|
|
Version 1.04.b - Increased available AGC delay to (216 - 1) cycles.
|
|
File size:
755 bytes
|
| Line | |
|---|
| 1 | README |
|---|
| 2 | |
|---|
| 3 | This Trigger Manager core was taken from the WARP v3 WARPLab 7.5.1 release. This is straight |
|---|
| 4 | copy of the w3 Trigger manager, renamed for the WARP v2 hardware, except for the following modifications: |
|---|
| 5 | |
|---|
| 6 | - Updated Model properties to reference w2_warplab_trigger_proc_init.m |
|---|
| 7 | - Removed CM-PLL support (both on debug inputs and outputs) |
|---|
| 8 | - Removed ETH A HW trigger support and all of ETH B trigger support, since it is not supported by the WARP v2 hardware |
|---|
| 9 | - Updated EDK processor block to use PLB bus and removed Ethernet Trigger registers |
|---|
| 10 | - Added pulse extender to the AGC trigger output since AGC runs at a slower clock speed |
|---|
| 11 | - i.e. The AGC core runs at 80 MHz in WARP v2 due to timing issues vs 160 MHz in WARP v3 |
|---|
| 12 | |
|---|
| 13 | |
|---|
| 14 | |
|---|
Note: See
TracBrowser
for help on using the repository browser.
