Changes between Version 24 and Version 25 of 802.11/Usage

Timestamp:

Jul 15, 2014, 5:25:21 PM (10 years ago)

Author:

murphpo

Comment:

--

802.11/Usage

@@ -52 +52 @@
 The 802.11 Reference Design AP and STA implementations use the WARP v3 board LEDs as status indicators.
 
-'''Green LEDs:''' increment for every error-free packet reception that passes the node's address filter
-'''Red LEDs:''' bottom two LEDs alternate on Rx PHY events which result in SIGNAL field errors; top two LEDs alternate on Rx PHY events with good SIGNAL field but bad payload checksum
-'''Hex Displays:'''
- * AP: the AP hex displays blink slowly to indicate the AP is accepting new association requests. The number of active associations is displayed.
- * STA: the STA displays the node's current AID (association ID), as assigned by the AP. When associated the STA displays 00.
+ * '''Green LEDs:''' increment for every error-free packet reception that passes the node's address filter
+ * '''Red LEDs:''' bottom two LEDs alternate on Rx PHY events which result in SIGNAL field errors; top two LEDs alternate on Rx PHY events with good SIGNAL field but bad payload checksum
+ * '''Hex Displays:'''
+  * AP: the AP hex displays blink slowly to indicate the AP is accepting new association requests. The number of active associations is displayed.
+  * STA: the STA displays the node's current AID (association ID), as assigned by the AP. When associated the STA displays 00.
 
 == Creating the SDK Workspace ==