[[TracNav(HardwareUsersGuides/FPGABoard_v1.2/TOC)]]

== WARP FPGA Board I/O ==

=== 10/100 Ethernet ===
[http://www.intel.com/design/network/products/lan/PHYs/lxt971a-972a.htm Intel LXT972A] physical layer Ethernet transceiver

[[Image(HardwareUsersGuides/FPGABoard_v1.2/Images:FPGA_Board_Ethernet.jpg)]]

Three status LEDs. LEDs only work after the PHY is initialized by a MAC in the FPGA.

||'''Label'''||'''Color'''||'''Component'''||'''Function'''||
||Activity||Green||D3||Blinks with network activity||
||Speed||Amber||D6||Glows for 100Mbit links||
||Link ||Green||D7||Glows with valid PHY link||

=== RS-232 UART ===
MAX3221 (from [http://www.maxim-ic.com/quick_view2.cfm/qv_pk/1069 Maxim] or [http://focus.ti.com/lit/ds/symlink/max3221.pdf TI]).

FPGA board configured just like a PC- male DB9 connector, Tx on 3, Rx on 2, GND on 5. Null-modem (crossover) female-female cable required to connect to PC's serial port.

=== Digital I/O ===
[[Image(HardwareUsersGuides/FPGABoard_v1.2/Images:FPGA_Board_DebugIO.jpg)]]

16-bits of unbuffered 3.3v I/O connected directly to FPGA I/O pins. 4 ground pins at each corner of 20-pin 0.1" header.

||Signal || FPGA Pin||
||Digital I/O [0]	||	K28||
||Digital I/O [1]	||	G30||
||Digital I/O [2]	||	H29||
||Digital I/O [3]	||	H30||
||Digital I/O [4]	||	J28||
||Digital I/O [5]	||	F30||
||Digital I/O [6]	||	E29||
||Digital I/O [7]	||	D30||
||Digital I/O [8]	||	K30||
||Digital I/O [9]	||	J30||
||Digital I/O [10]	||	K29||
||Digital I/O [11]	||	J29||
||Digital I/O [12]	||	G29||
||Digital I/O [13]	||	H28||
||Digital I/O [14]	||	F29||
||Digital I/O [15]	||	E30||