15 | | 1) Download a copy configuraiton file - TxDCO_Calibrate.bit |
16 | | 1) Use the DIP switch on the WARP FPGA Board to select which radios should be calibrated. Each switch position corresponds to a radio. The LSB (Radio #1) is the bottom switch; MSB (Radio #4) is the top. |
17 | | 1) Connect a serial cable to the FPGA board and set your terminal emulator to 57600bps |
18 | | 1) Power on the FPGA board and wait for a few minutes; this allows components to warm up |
19 | | 1) Configure the FPGA using TxDCO_Calibrate.bit |
20 | | 1) The terminal will display the status as it runs. Wait for the calibration of each radio to complete. |
| 15 | 1. Download a copy configuraiton file - TxDCO_Calibrate.bit |
| 16 | 1. Use the DIP switch on the WARP FPGA Board to select which radios should be calibrated. Each switch position corresponds to a radio. The LSB (Radio #1) is the bottom switch; MSB (Radio #4) is the top. |
| 17 | 1. Connect a serial cable to the FPGA board and set your terminal emulator to 57600bps |
| 18 | 1. Power on the FPGA board and wait for a few minutes; this allows components to warm up |
| 19 | 1. Configure the FPGA using TxDCO_Calibrate.bit |
| 20 | 1. The terminal will display the status as it runs. Wait for the calibration of each radio to complete. |