Changes between Version 18 and Version 19 of OFDMReferenceDesign

Timestamp:

Mar 30, 2007, 11:07:25 AM (17 years ago)

Author:

cjcamp

Comment:

--

OFDMReferenceDesign

@@ -16 +16 @@
 
 [[Image(OFDMReferenceDesign/Files:setup_01a.jpg)]]
+
+Before proceeding, verify that the Master Power switch on each WARP FPGA board has been switched to the OFF position.  
+
+[[Image(OFDMReferenceDesign/Files:setup_01b.jpg)]]
 
 Several cable connections must be made on each WARP kit before this demo may be performed:
@@ -40 +44 @@
 When power is applied to the WARP nodes, the value on the each board's 7-segment display (the one closer to the user DIP switches) should reflect these settings -- either "0" or "1".
 
-The compact flash configuration DIP switches permit the selection of different FPGA programs from a selection of programs stored on a compact flash card.  If you are configuring the FPGA boards using a compact flash card (instead of from a USB connection), then the configuration switches must be set to the correct value for the desired program.  In general, demo applications will be delivered on a compact flash card at location 0, so set the configuration DIP switches to the value 0000.
+The compact flash configuration DIP switches permit the selection of different FPGA programs from a selection of programs stored on a compact flash card.  If you are configuring the FPGA boards using a compact flash card (instead of from a USB connection), then the configuration switches must be set to the correct value for the desired program.  In general, demo applications will be delivered on a compact flash card at location 0, so set the configuration DIP switches to the value 0000.  DEPENDING UPON YOUR BOARD REVISION, THE SILKSCREEN NEAR THE CONFIGURATION DIP SWITCHES MAY INCORRECTLY SPECIFY THE DIRECTION FOR SWITCH VALUES 0 AND 1!  The value 0000 is achieved when all switches are pushed away from the nearest board edge.
 
+[[Image(OFDMReferenceDesign/Files:setup_06a.jpg)]]