Changes between Version 37 and Version 38 of OFDMReferenceDesign
- Timestamp:
- Nov 21, 2007, 9:41:24 AM (16 years ago)
Legend:
- Unmodified
- Added
- Removed
- Modified
-
OFDMReferenceDesign
v37 v38 14 14 == WARP Hardware Setup == 15 15 16 You will need two WARP nodes to test this reference design. Each node should have an antenna connected to the radio in daughtercard slot #2. Each node's Ethernet port should be connected to a PC, either directly or via a switch. The two WARP nodes should '''not''' be connected to the same Ethernet switch.16 You will need two WARP nodes to test this reference design. Each node should have an antenna connected to the radio in daughtercard slot !#2. Each node's Ethernet port should be connected to a PC, either directly or via a switch. The two WARP nodes should '''not''' be connected to the same Ethernet switch. 17 17 18 18 The two nodes will be programmed by the same bit file, but they must be uniquely identified to allow the wireless MAC layer to properly address each node. The FPGA board's DIP switch is used to identify each node. One board should have its DIP switch set to all zeros (0000); the other should be set to 0001. See the figure below for the proper settings.
