Changes between Version 1 and Version 2 of UserIO_Reference_Guide/sw_setup

Timestamp:

Feb 8, 2007, 10:44:58 PM (17 years ago)

Author:

djr

Comment:

--

UserIO_Reference_Guide/sw_setup

@@ -4 +4 @@
  1. Start XPS via '''Program Files''' => '''Xilinx Platform Studio 8.1i''' => '''Xilinx Platform Studio'''
  2. At the '''Create new or open existing project''' window, select '''Base System Builder wizard (recommended)''' and click '''OK'''
+
+[[Image(UserIO_Reference_Guide/Images:Picture_001.jpeg)]]
+
  3. For '''Project file''', browse to the directory in which you would like to store your project.  Create a new folder within this directory and open it.  The file name should be ''system.xmp''.  Click '''Save'''. XPS will save all the various project files and folders in this project folder.  Click '''OK''' to move to tthe next window.
+
+[[Image(UserIO_Reference_Guide/Images:Picture_002.jpeg)]]
+
  4. The '''Base System Builder - Welcome''' window should appear.  Select '''I would like to create a new design''', and click '''Next'''
+
+[[Image(UserIO_Reference_Guide/Images:Picture_003.jpeg)]]
+
  5. At the '''Select Board''' window, make the following selections and click '''Next''':
    * Board vendor: ''Rice University CMC - WARP Project''
    * Board name: ''WARP FPGA and Radio Boards''
    * Board revision: ''1.0a''
+
+[[Image(UserIO_Reference_Guide/Images:Picture_004.jpeg)]]
+
  6. Make sure '''PowerPC''' is your selected processor.  Click '''Next'''
+
+[[Image(UserIO_Reference_Guide/Images:Picture_005.jpeg)]]
+
  7. The '''Configure PowerPC''' window should appear, make the following designations and click '''Next''':
    * Processor clock frequency: ''100.00 MHz''
@@ -19 +34 @@
      * Instruction: ''128 KB''
    * Cache setup should be ''unchecked''
+
+[[Image(UserIO_Reference_Guide/Images:Picture_006.jpeg)]]
+
  8. The next windows are '''Configure IO Interfaces'''.  Depending on the size of your window, a varying number of IO devices will be available on each screen.  Make sure the following are checked (if an attribute is not enumerated, assume default configuration):
    * ''LED_7SEGMENT''
@@ -31 +49 @@
    * ''DIPSWs_4bit''
    * '''UNCHECK''': ''SysACECompactFlash'', ''Ethernet_MAC'', ''radio_controller_0'', ''radio_bridge_slot_2'', ''SRAM0_ZBT_512Kx32'', and ''SRAM1_ZBT_512Kx32''
+
+[[Image(UserIO_Reference_Guide/Images:Picture_007.jpeg)]]
+
  9. At '''Add Internal Peripherals''', click '''Remove''' in the right of the '''plb_bram_if_cntlr_1''' box. Click '''Next'''
  10. At '''Software Setup''', UNCHECK '''Memory test''' and '''Peripheral selftest'''.  '''RS232''' should be chosen for '''STDIN''' and '''STDOUT'''.  Click '''Next'''.