Changes between Version 1 and Version 2 of WARPLab/HardwareConfiguration/WARPv3


Ignore:
Timestamp:
May 14, 2013, 2:44:58 PM (11 years ago)
Author:
welsh
Comment:

--

Legend:

Unmodified
Added
Removed
Modified

  • WARPLab/HardwareConfiguration/WARPv3

    v1 v2  
    3636The WARPLab reference design does not require any external clock connections. By default the reference design will use the oscillators on the WARP v3 board for all system and RF clocking.
    3737
    38 The reference design does support both sourcing and sinking external clocks for synchronization of multiple nodes. The WARP v3 kit must be equipped with a CM-MMCX clock module to source/sink clocks. The role of each node is configured via the 2-position SIP switch on the CM-MMCX, according to the figure below.
     38The reference design does support both sourcing and sinking external clocks for synchronization of multiple nodes. The WARP v3 kit must be equipped with a [wiki:HardwareUsersGuides/CM-MMCX CM-MMCX Clock Module] to source/sink clocks. The role of each node is configured via the 2-position SIP switch on the CM-MMCX, according to the figure below.
    3939
    4040  * Detailed information on the WARP v3 Clocking configuration can be found [wiki:HardwareUsersGuides/WARPv3/Clocking here].
    41   * To adjust the [wiki:HardwareUsersGuides/CM-MMCX MMCX Clock Module] functionality, please use the following SIP switch settings:
     41  * To adjust the [wiki:HardwareUsersGuides/CM-MMCX CM-MMCX Clock Module] functionality, please use the following SIP switch settings:
    4242
    4343[[Image(MMCX_v1_labelled.png)]]