Changes between Version 21 and Version 22 of WARPLab6/GettingStarted

Timestamp:

Nov 15, 2012, 11:10:42 AM (12 years ago)

Author:

chunter

Comment:

--

WARPLab6/GettingStarted

@@ -14 +14 @@
 
  6. Set the DIP switches on the two WARP boards to zero (0000) and one (0001).
-[[Image(OFDMReferenceDesign/Files:DIP_switches.jpg)]]
+||[[Image(v1Switch.jpg,width=400,link=[attachment:v1Switch.jpg])]]||[[Image(v2Switch.jpg,width=400,link=[attachment:v1Switch.jpg])]]||[[Image(v3Switch.jpg,width=400,link=[attachment:v1Switch.jpg])]]||
+||   '''[attachment:v1Switch.jpg WARP v1 (Enlarge Image)]'''  ||  '''[attachment:v2Switch.jpg WARP v2 (Enlarge Image)]'''  ||  '''[attachment:v3Switch.jpg WARP v3 (Enlarge Image)]'''  ||
 
  7. Download the WARPLab bitstream to both boards. The latest WARPLab bitstream is available [wiki:WARPLab/Releases here]. A Virtex-II Pro FPGA kit uses the {{{_FPGAv1}}} suffix while the Virtex-4 FPGA kit uses the {{{_FPGAv2}}} suffix for all files. The bitstream can be downloaded either via an external JTAG cable, via a USB cable (connected to the FPGA board's USB port) or a CompactFlash card. Instructions on formatting and loading systems on to a Compact Flash are available [wiki:sysace/formatload#FormattingandLoadingSystemsontoaCompactFlash here]. After downloading the bitstreams, the right hex display on the WARP boards should show a single digit 1 for the board with DIP switch set to zero and a single digit 2 for the board with DIP switch set to one. This digit is the last octet of the board's IP address (10.0.0.1 or 10.0.0.2).