You are not logged in.
Hello, I'm Toan!
In process implement 802.11 Reference Design on WARP V3 KIT, my WARP V3 KIT have a error notified on Hex LED is "E2". When I turn off KIT then have two LED is light, but normal is only one LED light. Help me about the error.
This is ficture before and after turn off the KIT. https://photos.google.com/photo/AF1QipO … wkqx2rg8oT and https://photos.google.com/photo/AF1QipM … gZnp1m3_xd
This is ficture on terminal of UART: https://photos.google.com/photo/AF1QipM … RCK4f70rvn
Thank you!
Last edited by toance0901 (2017-Apr-11 04:13:18)
Offline
Unfortunately your photo links do not work. However error code E2 means the SO-DIMM wasn't detected at boot. This can happen if the SO-DIMM is dislodged or damaged, or if one of the DRAM power supplies has failed. Verify the SO-DIMM is properly installed on your kit.
Offline