You are not logged in.
hello.
I've tried install WARPLab Reference Design (.bin file) by using sd card.
and I already read and read 'https://warpproject.org/trac/wiki/howto/SD_Config' and 'https://warpproject.org/trac/wiki/howto/SD_Config/Windows'.
I obtained message below:
'18032+1 records in
18032+1 records out'
however, when I insert SD card into Warp v3 H/W card slot, Warp does not work and does not make any changes..(No segment led, err led, stat led.. all led off..)
moreover, I tried to change all of Dip switch's numbers..but it does not work still.
I think that if SD card with reference bin file is inserted into the Warp correctly, the Warp Hardware is installed automatically. is it right? but in this case, it does not work. I don't know why Warp does not work. could you help me?
thank you.
Offline
Make sure all 4 switches on the reconfig DIP switch (SW2) are down (towards "0" on the switch). This is required to select configuration via the SD card from slot #0 on the card.
Other than that, there's not much we can do to help debug writing the SD card. It's worth trying a different SD card (must be <=2GB standard SD card, not SDHC or SDXC), a different USb-SD card adapter, different PC, etc.
Offline