WARP Project Forums - Wireless Open-Access Research Platform

You are not logged in.

#26 2018-Apr-05 01:20:19

smit_smu
Member
From: Sikkim, India
Registered: 2013-Feb-24
Posts: 73

Re: Radio Card Configuration of V2 Board

I am using a Different transmitter which is not connected in the same IP domain of WARP board.

Offline

 

#27 2018-Apr-06 01:28:38

smit_smu
Member
From: Sikkim, India
Registered: 2013-Feb-24
Posts: 73

Re: Radio Card Configuration of V2 Board

Dear Sir,

My MXH working as TX, i have configured with Ip : 10.0.0.252, Subnet Mask : 255.0.0.0

Can I Read Ethernet Trigger from Mixed Signal generator and use to Trigger Receiver WARP Board.

Offline

 

#28 2018-Apr-06 09:25:40

murphpo
Administrator
From: Mango Communications
Registered: 2006-Jul-03
Posts: 5159

Re: Radio Card Configuration of V2 Board

Can I Read Ethernet Trigger from Mixed Signal generator and use to Trigger Receiver WARP Board.

I don't know, I've never used that instrument. However it is unlikely the instrument can send an Ethernet packet containing a WARPLab trigger command.

Offline

 

#29 2018-Apr-06 22:52:58

smit_smu
Member
From: Sikkim, India
Registered: 2013-Feb-24
Posts: 73

Re: Radio Card Configuration of V2 Board

As my TX is always on, Energy Trigger will not work. As My Tx is Not a WARP board, so difficult to use Ethernet Trigger. In that case Only option is External Trigger.

My Generator is having a Trigger Output (BNC Connector). If I connect that output with WARP Trigger Input 3 (P15) and Ground using a pair of wires, then it will work?

Offline

 

#30 2018-Apr-10 01:10:36

smit_smu
Member
From: Sikkim, India
Registered: 2013-Feb-24
Posts: 73

Re: Radio Card Configuration of V2 Board

Dear Sir,

I am middle of a Project, if you can reply me, i will be a great help to me.

As my TX is always on, Energy Trigger will not work. As My Tx is Not a WARP board, so difficult to use Ethernet Trigger. In that case Only option is External Trigger.

My Generator is having a Trigger Output (BNC Connector). If I connect that output with WARP Trigger Input 3 (P15) and Ground using a pair of wires, then it will work?

Offline

 

#31 2018-Apr-10 09:21:06

murphpo
Administrator
From: Mango Communications
Registered: 2006-Jul-03
Posts: 5159

Re: Radio Card Configuration of V2 Board

We can't tell you if your experiment will work - you need to review the specs and try it. As I said above the WARP v2 digital inputs are 3.3v pins; any external trigger signal must be a [0, 3.3v] signal to avoid damaging the FPGA I/O buffers.

Offline

 

#32 2018-Apr-11 01:10:31

smit_smu
Member
From: Sikkim, India
Registered: 2013-Feb-24
Posts: 73

Re: Radio Card Configuration of V2 Board

OK thank you Sir

Offline

 

Board footer