You are not logged in.
I am doing full duplex implementation on warp board. In full duplex the main problem is self interference effect. To observe and to cancel that effect i need to make RF_A as a transmitter and RF_B as a receiver on warp board. How to make RF_A as transmitter and RF_B as a receiver on single warp board???
Last edited by Bobbili Vinitha (2018-Jun-26 00:24:58)
Offline
I would suggest using the WARPLab Reference Design. WARPLab supports simultaneous use of RFA and RFB, with each interface configured as Tx or Rx.
Offline