You are not logged in.
Hello,
I'm new to the WARP project and I have a question about the FPGA board. I have used for work a Xilinx XC2V1000-4FG256 VIRTEX II FPGA board together with Xilinx Tools and Matlab. Is this board compatible with the WARP software and libraries or must the specific WARP FPGA Board shown on the Mango Communications site be used?
Thank you.
Offline
The source for all of our models and peripheral cores in the repository can be targeted to any Xilinx Virtex-II (or later) device. However, a 2V1000 is quite a bit smaller than the V2P70 on the WARP FPGA board, so the full MAC+PHY designs probably won't fit as-is.
Offline