You are not logged in.
hi
I purchased a warp eval kit3 board and i have some problems with it , the noise from the ADC looks like a sine wave ,
I changed the channel frequency (band 5 ghz) but i get always the same result , is this due max2829 or AD9963 please help
attached image in following link
https://ibb.co/bHgkvk
the red is imaginary part and blue is the real part
Offline
What is the serial number of your kit (W3-a-NNNNN)? I can check our records for its manufacturing calibration data.
Are you using one of our reference designs (i.e. WARPLab)?
Offline
no I use a custom code and i delete every thing in the eeprom, did you see this phenomena in other board
please can you tell me the procedure to correct this issue
Offline
no I use a custom code and i delete every thing in the eeprom
The serial number is also printed on a label on the top of the board, just to the right of the SO-DIMM.
did you see this phenomena in other board, please can you tell me the procedure to correct this issue
I would recommend starting with our WARPLab Reference Design and verifying the Tx/Rx I/Q signals are clean with this known-good design. Otherwise you'll have to provide more details about your custom design for us to help. A sinusoid in the Rx I/Q signal could be caused by many things.
Offline
in my design i configured the ad9963 and max2829 and the clock generator as described in your code , the transmitter path is functional , the only problem is with rx path ,
A sinusoid in the Rx I/Q signal could be caused by many things.
can you list this things that can cause this problem
Offline