WARP Project Forums - Wireless Open-Access Research Platform

The WARP v3 board has two RF interfaces labeled RF A and RF B. You can assign whatever Tx/Rx signals you want to each RF interface. For example, in the WARPLab MIMO OFDM Example constructs two complex waveforms tx_vec_air_A and tx_vec_air_B, then assigns these to RF interfaces A and B. You can swap which waveform is assigned to which antenna by changing these variables.

I'm sorry, I don't understand what you're asking.

The DONE signal is asserted by the Viterbi decoder block when it has decoded the last byte of the packet payload. You should observe a DONE signal for any modulation/coding rate if the Rx PHY was able to decode the packet header and attempted to decode the packet payload.