You are not logged in.
I am using a Different transmitter which is not connected in the same IP domain of WARP board.
Offline
Dear Sir,
My MXH working as TX, i have configured with Ip : 10.0.0.252, Subnet Mask : 255.0.0.0
Can I Read Ethernet Trigger from Mixed Signal generator and use to Trigger Receiver WARP Board.
Offline
Can I Read Ethernet Trigger from Mixed Signal generator and use to Trigger Receiver WARP Board.
I don't know, I've never used that instrument. However it is unlikely the instrument can send an Ethernet packet containing a WARPLab trigger command.
Offline
As my TX is always on, Energy Trigger will not work. As My Tx is Not a WARP board, so difficult to use Ethernet Trigger. In that case Only option is External Trigger.
My Generator is having a Trigger Output (BNC Connector). If I connect that output with WARP Trigger Input 3 (P15) and Ground using a pair of wires, then it will work?
Offline
Dear Sir,
I am middle of a Project, if you can reply me, i will be a great help to me.
As my TX is always on, Energy Trigger will not work. As My Tx is Not a WARP board, so difficult to use Ethernet Trigger. In that case Only option is External Trigger.
My Generator is having a Trigger Output (BNC Connector). If I connect that output with WARP Trigger Input 3 (P15) and Ground using a pair of wires, then it will work?
Offline
We can't tell you if your experiment will work - you need to review the specs and try it. As I said above the WARP v2 digital inputs are 3.3v pins; any external trigger signal must be a [0, 3.3v] signal to avoid damaging the FPGA I/O buffers.
Offline
OK thank you Sir
Offline