#ifndef W3_PLATFORM_COMMON_H_
#define W3_PLATFORM_COMMON_H_

#include "xparameters.h"


#define PLATFORM_ID_W3 		0x00000001
#define PLATFORM_CONFIG 	0x00000000

/*********************************************************************
 * Mapping macros from xparameters.h
 *
 * The BSP generates xparameters.h to define macros for hardware-specific
 * parameters, including peripheral memory addresses, peripheral IDs,
 * interrupt IDs, etc.
 *
 * The macros below map the BSP-generated macros ("XPAR_...") to the
 * hardware-agnostic names used by the 802.11 Ref Design C code. Each
 * platform must implement this mapping in wlan_platform_common.h.
 *
 **********************************************************************/

// --------------------------------------------------------------------
// Peripherals accessible by both CPUs

// IIC EEPROMs - WARP v3 on-board and FMC-RF-2X245 EEPROMs
#define EEPROM_BASEADDR			XPAR_W3_IIC_EEPROM_ONBOARD_BASEADDR
#define FMC_EEPROM_BASEADDR  	XPAR_W3_IIC_EEPROM_FMC_BASEADDR

// IPC mailbox
#define PLATFORM_DEV_ID_MAILBOX    XPAR_MBOX_0_DEVICE_ID

// System monitor
#define PLATFORM_BASEADDR_SYSMON   XPAR_SYSMON_0_BASEADDR


// Mutex for Tx/Rx packet buffers
#define PLATFORM_DEV_ID_PKT_BUF_MUTEX	XPAR_MUTEX_0_DEVICE_ID


// Tx Power range
#define TX_POWER_MAX_DBM                                  (21)
#define TX_POWER_MIN_DBM                                  (-9)

#endif /* W3_PLATFORM_COMMON_H_ */