WARP v3 User Guide: RF Interfaces

The WARP v3 board integrates two identical RF interfaces. The basic structure of each interface is illustrated below.

AD9963 ADC/DAC

The conversion between the analog I/Q and digital I/Q domains is handled by the Analog Devices AD9963 MxFE. The AD9963 integrates two 100MSps 12-bit ADCs, two 170MSps 12-bit DACs, interpolation and decimation filters and programmable analog gain and offset adjustments. Refer to the ADI ​AD9963 datasheet for full specifications.

The AD9963 is very flexible and includes a register bank to control various functions on the chip. The registers are accessed via a dedicated SPI interface. We have designed the w3_ad_controller core to access the AD9963 registers via the SPI interface.

The digital I/Q ports on the AD9963 operate at double data rate, with I/Q interleaved. We have designed the w3_ad_bridge core to connect these DDR ports to separate internal I/Q busses in user designs.

MAX2829 Transceiver

The WARP v3 RF interfaces use the Maxim MAX2829 transceiver to translate between baseband and RF. The MAX2829 implements both 2.4 and 5GHz Tx/Rx paths. For full specifications refer to the ​MAX2829 datasheet.

The MAX2829 transceiver has a number of digital control lines and a dedicated SPI interface for internal register access. We have designed the radio_controller core to manage these control interfaces in user designs.

Each transceiver generates its own RF carrier signal, derived from a reference clock input. The reference clocks for both RF interfaces are driven by an AD9512 clock buffer (see for details). The MAX2829 requires either a 20MHz or 40MHz reference clock. The AD9512 must be configured to divide its 80MHz input to generate the desired reference frequency.

Power Amplifier

The WARP v3 design currently uses the Anadigics AWL6951 dual-band power amplifier. Every board is tested to ensure >20dBm output power at both 2.4 and 5GHz. Refer to the ​AWL6951 datasheet for full specifications.

RF Port

Each RF interface is connected to a 50 ohm SMA jack. This connector is a standard polarity, standard thread SMA jack. The SMA jack should always be terminated into a 50 ohm load. The WARP v3 kit includes SMA terminators for each RF interface. Users must supply their own RF cables or antennas to suit their application.

The maximum input power at the SMA connector should never exceed 0dBm, to avoid damage to the MAX2829 RF inputs.

The performance of the MAX2829 RF inputs are specified for input powers below approximately -10dBm. To connect two WARP v3 kits via a coax cable, ensure there is at lest 40dB series attenuation.