Changes between Version 23 and Version 24 of OFDMReferenceDesign

Timestamp:

Mar 30, 2007, 12:48:54 PM (17 years ago)

Author:

cjcamp

Comment:

--

OFDMReferenceDesign

@@ -65 +65 @@
 
 Switch the Master Power Switch for each FPGA board to the ON state.
-Configure the FPGA boards using either 1) a compact flash card containing the demo program, or 2) a USB cable connected between the FPGA board and a computer running the Xilinx iMPACT software application.  The laboratory exercise titled [http://warp.rice.edu/trac/wiki/Exercises/FPGABoardIntro INTRODUCTION TO THE WARP FPGA BOARD] provides a brief introduction to the iMPACT software application, including required cable connections.  For configuration using a compact flash card, simply insert the card into the appropriate slot on each FPGA board.  An photo of the compact flash card slot appears below.
+Configure the FPGA boards using either 1) a compact flash card containing the demo program, or 2) a USB cable connected between the FPGA board and a computer running the Xilinx iMPACT software application.  The laboratory exercise titled [http://warp.rice.edu/trac/wiki/Exercises/FPGABoardIntro INTRODUCTION TO THE WARP FPGA BOARD] provides a brief introduction to the iMPACT software application, including required cable connections.  For configuration using a compact flash card, simply insert the card into the appropriate slot on one of the FPGA boards.  An photo of the compact flash card slot appears below.
 
 [[Image(OFDMReferenceDesign/Files:setup_07a.jpg)]]
 
-Once the first FPGA boars has been configured, the compact flash card may be removed for configuration of the other board.  Before removing it, however, verify proper configuration by examining the board's 7-segment LEDs.  The one closer to the user DIP switches should display the value programmed into the switches -- either "0" or "1".
+Once the first FPGA boars has been configured, the compact flash card may be removed for use in configuring of the other board.  Before removing it, however, verify proper configuration by examining the board's 7-segment LEDs.  The one closer to the user DIP switches should display the value programmed into the switches -- either "0" or "1".