Changes between Version 5 and Version 6 of Radio Board


Ignore:
Timestamp:
Jan 21, 2007, 8:52:55 PM (17 years ago)
Author:
murphpo
Comment:

--

Legend:

Unmodified
Added
Removed
Modified

  • Radio Board

    v5 v6  
    55[[Image(WARPImages:WARP_RadioBoard_Photo_sm.jpg)]]
    66
    7 The TAP radio board's RF chain is completed by bandpass filters, a dual-band power amplifier and a Tx/Rx switch. The amplifier in the current design is capable of transmitting OFDM waveforms at 18 dBm. Future revisions of the board will likely incorporate more powerful amplifiers which will be better suited to long-range, outdoor deployment.
     7The WARP radio board's RF chain is completed by bandpass filters, a dual-band power amplifier and a Tx/Rx switch. The amplifier in the current design is capable of transmitting OFDM waveforms at 18 dBm. Future revisions of the board will likely incorporate more powerful amplifiers which will be better suited to long-range, outdoor deployment.
    88
    9 The TAP radio board is a 6-layer, 2x3"  (4.5x7cm) PCB. The board houses all of the components necessary to provide a purely digital interface to the host board's FPGA. Dedicated linear power regulators are also used to meet the low noise requirements of the data converters and RF transceiver. The RF signals are routed to board-edge connectors to provide flexibility in the selection and arrangement of antennas.
     9The WARP radio board is a 6-layer, 2x3"  (4.5x7cm) PCB. The board houses all of the components necessary to provide a purely digital interface to the host board's FPGA. Dedicated linear power regulators are also used to meet the low noise requirements of the data converters and RF transceiver. The RF signals are routed to board-edge connectors to provide flexibility in the selection and arrangement of antennas.
    1010
    1111= WARP Radio Board Design Files =