Changes between Version 12 and Version 13 of WARPLab6/Architecture
- Timestamp:
- May 6, 2013, 4:19:35 PM (11 years ago)
Legend:
- Unmodified
- Added
- Removed
- Modified
-
WARPLab6/Architecture
v12 v13 1 [[TracNav(WARPLab /TOC)]]1 [[TracNav(WARPLab6/TOC)]] 2 2 3 3 = WARPLab FPGA Design Architecture = … … 5 5 Tx and Rx paths for one antenna are shown in the figure below, blocks in the Tx Path are highlighted in pink and blocks in the Rx path are highlighted in blue. The blocks are described below. 6 6 7 [[Image(WARPLab /Images:siso_arch.jpg, 900px)]]7 [[Image(WARPLab6/Images:siso_arch.jpg, 900px)]] 8 8 9 9 Blocks on transmitter path: … … 32 32 The system generator model in the Reference Design enables all four radios. The above model is replicated for four radios and the final block diagram is shown in the following figure. 33 33 34 [[Image(WARPLab /Images:mimo_arch.jpg, 1100px)]]34 [[Image(WARPLab6/Images:mimo_arch.jpg, 1100px)]] 35 35 36 36 Any subset of the radios can be used - not every slot must contain a radio board. The outputs from the model describe radios connected in the following slots. For example, output of antenna 2 is connected to the radio in daughtercard slot 2. 37 37 38 [[Image(WARPLab /Images:4AntennaNode.jpg, 500px)]]38 [[Image(WARPLab6/Images:4AntennaNode.jpg, 500px)]]