Changes between Version 18 and Version 19 of WARPLab6/GettingStarted


Ignore:
Timestamp:
Feb 17, 2012, 11:44:34 PM (12 years ago)
Author:
murphpo
Comment:

--

Legend:

Unmodified
Added
Removed
Modified

  • WARPLab6/GettingStarted

    v18 v19  
    33= Getting Started =
    44
    5  1. Requirements: At least two WARP nodes, a PC with MATLAB and an Ethernet switch. '''Please note:''' the current WARPLab reference design uses a 100Mb Ethernet link. Users with WARP FPGA v2 boards will need to use a 100Mb switch to force the FPGA Board Ethernet PHY into 100Mb mode.
     5 1. Requirements: At least two WARP nodes, a PC with MATLAB and an Ethernet switch. '''Please note:''' the current WARPLab reference design uses a 100Mb Ethernet link. Users with WARP FPGA v2 (Virtex-4 FPGA) boards will need to use a 100Mb switch to force the FPGA Board Ethernet PHY into 100Mb mode.
    66
    77 2. Install Peter Rydesäter's open-source TCP/UDP toolbox for MATLAB (get it free from [http://www.mathworks.com/matlabcentral/fileexchange/345 MATLAB Central]). You may need to re-compile the pnet mex source for your version of Windows/MATLAB. For 64-bit Windows 7, see [http://warp.rice.edu/forums/viewtopic.php?pid=4363#p4363 this forum post].