Changes between Version 4 and Version 5 of WARPLab6/GettingStarted

Timestamp:

Sep 16, 2009, 3:31:10 PM (15 years ago)

Author:

mduarte

Comment:

--

WARPLab6/GettingStarted

@@ -12 +12 @@
 
  6. Set the DIP switches on the two WARP boards to zero (0000) and one (0001).
+[[Image(OFDMReferenceDesign/Files:setup_05a.jpg)]]
 
  7. Download the WARPLab bitstream to both boards. The latest WARPLab bitstream is available HEEERRREE. The bitstream can be downloaded either via an external JTAG cable, via a USB cable (connected to the FPGA board's USB port) or a CompactFlash card. Instructions on formatting and loading systems on to a Compact Flash are available [wiki:sysace/formatload#FormattingandLoadingSystemsontoaCompactFlash here]. After downloading the bitstreams, the right hex display on the WARP boards should show a single digit 1 for the board with DIP switch set to zero and a single digit 2 for the board with DIP switch set to one. This digit is the last octet of the board's IP address (10.0.0.1 or 10.0.0.2). 
 
- 8. Try one of the examples. The GUI (warplab_mimo_2x2_GUI and the warplab_siso_example_TxRx) are the best ones to start with. The latest version of the examples is available HEERRREE.
+ 8. Try one of the examples. The GUI (warplab_mimo_2x2_GUI and the warplab_siso_example_TxRx) are the best ones to start with. The latest version of the M-Code examples is available HEERRREE.