Changes between Version 4 and Version 5 of peripheral_test/hw_setup
- Timestamp:
- May 25, 2006, 7:46:24 AM (18 years ago)
Legend:
- Unmodified
- Added
- Removed
- Modified
-
peripheral_test/hw_setup
v4 v5 17 17 3. '''Connect and Power the WARP FPGA Board''' 18 18 * Connect a 12V-DC power supply to the FPGA board. (The connection to the board is in the bottom right corner on the bottom side) 19 * Turn the power switch on. The switch located to the left of the power connection. (Turning on the board should cause a number of LEDs to light. If there is no flash card in the flash port, then the LED near the flash port will blink until one is inserted. This is not needed now.)19 * Turn the power switch on. The switch is located to the left of the power connection. (Turning on the board should cause a number of LEDs to light. If there is no flash card in the flash port, then the LED near the flash port will blink until one is inserted. This is not needed now.) 20 20