You are not logged in.
Dear Sir,
When I power-on WARP platform (WARPLAB bit file )the TX/RX led indicate light few sec.
https://www.dropbox.com/s/qwn4hnjljyddj … 9.JPG?dl=0
UART:
https://www.dropbox.com/s/ler3xqcd6tjdv … 5.JPG?dl=0
https://www.dropbox.com/s/cm0v65w6prbwg … 7.JPG?dl=0
Is it normal?
Best Regards,
Paul
Offline
Do you mean the LEDs near the RF interfaces on the FMC-RF-2X245 module? It is normal that these illuminate before the FPGA is configured. After the FPGA is configured these LEDs behave the same way as the LEDs near the on-board RF interfaces (green=Tx, red=Rx).
Offline
Dear murphpo,
Thanks for your support.
Best Regards,
Paul
Offline