You are not logged in.
when i am running the codes from M_code examples i am getting the error
Error using wl_initNodes (line 164)
The following nodes with IDs = [ 1 0 ] are not responding. Please ensure that the nodes have been configured with the WARPLab
bitstream.
Error in wl_example_basic_txrx (line 20)
nodes = wl_initNodes(2);
What does this indicate ? what should i do to avoid it
Offline
Did you follow the Getting Started instructions in the WARPLab User Guide?
Offline
when i run w3_WARPLab_7.7.1_2RF bitstream on two warp nodes they display node id as 01 & 02 but when i run w3_WARPLab_7.7.1_4RF bitstream on two warp board both of them shows same ids 23 should they have different ids? How to change the WARP id.
Offline
The w3_WARPLab_7.7.1_4RF bitstream is for WARP v3 nodes equipped with FMC-RF-2X245 modules (i.e. 4-antenna nodes). What is your hardware configuration?
Offline
OK in that case if i connect 4 antenna nodes to the WARP v3 board then only it can configured with w3_WARPLab_7.7.1_4RF . Thank you sir.
Offline
Earlier I downloaded WARP_Repository using the path E:\WARP_Repository. But when i deleted that folder and tried to download WARP_Repository using path C:\WARP_Repository, I am not able to do so. Getting error at SVN Checkout, its not responding. Can you help me out?
Offline