You are not logged in.
In the OFDM reference design, under OFDM Rx MIMO/ADCs & Filter/Antenna Selection block, output port #3 (B I output) seems to be incorrectly connected to the AntA_Q input rather than AntB_I. The same block in the ResearchApps version however seems to be fine. Am I missing something?
Offline
Never mind. I found out an earlier post which confirmed this to be a bug.
Offline
Please double check that you're using the right version of the reference design. For new kits, which are built with the final clocking configuration, you should be using reference design v07 (whose OFDM model has this bug fixed).
Offline