Changes between Version 5 and Version 6 of WARPLab/HardwareConfiguration


Ignore:
Timestamp:
May 14, 2013, 2:18:52 PM (11 years ago)
Author:
murphpo
Comment:

--

Legend:

Unmodified
Added
Removed
Modified

  • WARPLab/HardwareConfiguration

    v5 v6  
    22
    33= Hardware Configuration =
     4Intro (mapping of hw resources to features in ref design; for deatils on hw resources, see UGs)
    45
    56== System Requirements ==
    … …  
    4041
    4142=== Clock Configuration ===
     43The WARPLab reference design does not require any external clock connections. By default the reference design will use the oscillators on the WARP v3 board for all system and RF clocking.
     44
     45The reference design does support both sourcing and sinking external clocks for synchronization of multiple nodes. The WARP v3 kit must be equipped with a CM-MMCX clock module to source/sink clocks. The role of each node is configured via the 2-position SIP switch on the CM-MMCX, according to the figure below.
    4246
    4347  * Detailed information on the WARP v3 Clocking configuration can be found [wiki:HardwareUsersGuides/WARPv3/Clocking here].